RCBS Rock Chucker Press Bushing question

[MT257]

Does anyone know where I may be able to find a bushing for my RCBS Rock Chucker IV press? The bushing I am looking for is the one that is the black colored bushing that screws into the press. The die then screws into this bushing.

 

[cptjack]

callnrcbs

 

[Shooter13]

RCBS will give you one if you call, if you can't get in touch with them let me know as I may have an extra.

 

[M-61]

You can email or call RCBS and experience the best customer service I have ever seen from any company for so long.

 

[6.5 forever]

RCBS is has fantastic CS. Their Techs must all be shooters!!

 

[Big Mc]

Does anyone know where I may be able to find a bushing for my RCBS Rock Chucker IV press? The bushing I am looking for is the one that is the black colored bushing that screws into the press. The die then screws into this bushing.

RCBS W I L L make it right. Tommy Mc

 

[Bill K]

Simple answer, call RCBS and they will, more than likely, send you one free or for a very reasonable fee.

 

[Fuj]

They usually come with one. Mine did, so RCBS should just send
you one.

 

[Machinist John]

Call RCBS or Huntington Die Services

 

[Thud]

MT,
What's wrong with your bushing

 

[MT257]

MT,
What's wrong with your bushing

Not sure if the threads are messed up or what. I cannot get the die to screw in a whole turn with out it getting tight.

 

[Thud]

try a little oil. mine was like that. it helped. or check die threads.

 

[MT257]

try a little oil. mine was like that. it helped. or check die threads.

I've cleaned both the die and bushing threads.I'll try some oil. I have sent an email to RCBS hopefully I hear back from that. I am not sure if I would be fine just running a tap back through the bushing or not.

 

[6.5 forever]

What die are you using?

 

[Thud]

rcbs, whidden, redding,wilson

 

[Ray123]

I've cleaned both the die and bushing threads.I'll try some oil. I have sent an email to RCBS hopefully I hear back from that. I am not sure if I would be fine just running a tap back through the bushing or not.

Clean and lube both threads, blow out with compressed air both, look for nicks, chips & debris in threads. The die and press should have 7/8×14 thread...try a different "clean" die see if it will screw in...if not oil & retap threads in press....clean & try die again...all dies should then thread in. Or order a new one from RCBS.

 

[MT257]

rcbs, whidden, redding,wilson

I’ve got both hornady and rcbs.

 

[Thud]

They should all work as stated before clean threads and lightly oil should.
Check your dies for buggered threads.

 

[JMayo]

clean threads with a brush .. maybe

 

[MT257]

clean threads with a brush .. maybe

I have used a brush on both bushing and die. Still have same problem. Gonna give RCBS a shout in morning if not I will try finding a tap.