RCBS case trimmer mods question???

[Ogre6br]

Can you make or is there an adaptor for the RCBS case trimmer to enable you to fit a power screwdriver???

Approx cost shoud I be looking at for the RCBS case trimmer and the lever loading attachment- .223 and 308??


this is the adaptor In talking about-

http://cgi.ebay.com.au/RCBS-Case-Holder-Accessory-for-RCBS-case-trimmers_W0QQitemZ7240325232QQcategoryZ383QQrdZ1QQcmdZViewItem
Thanks

Later
p

 

[harvey13118]

I used a long screw and replaced the screw that currently holds the handle. I also used a jam nut just to keep it tight in the threads. You could also try a flexible drive shaft. I'd thought that was a good idea also.

My nephew has that trimmer and I have the new style with the lever for the shell plate.

I can not for the life of me get the case square unless I keep pressure on the handle and move the pilot into the case while turning slowly then release the handle and trim.

 

[Terje338]

I just make this modification on my RCBS case trimmer

The little Bosch electric screwdriver works very well, and it speeds up the case trimming process quite a bit.

Terje