Quick change adjustable length of pull hardware needed

[missed]

I need to put an adjustable length of pull hardware on my 10/22. The stock is the correct length for me, but about 3" to long for my daughter. My thought is to cut it down, put the recoil pad on a plate, build a plate for the stock, bore two holes for rods in the plate for the length adjustment, bolt the end of the rods to the recoil pad plate. Making a quick no tool length change is my goal, I had thought about notches in the rod that the rods can lock into with a lever controlling the locking device.

Are there any production hardware kits out there?

Any feedback on my idea?

Thanks!

Jake

 

[watercam]

Check with Brownells. The match units we use will run about $140 for the hardware for adjustable LOP, butt plate cant and elevation. Sounds like all you need is LOP. There are units for shotguns that do just that.

 

[missed]

Check with Brownells. The match units we use will run about $140 for the hardware for adjustable LOP, butt plate cant and elevation. Sounds like all you need is LOP. There are units for shotguns that do just that.

I'll have to look a bit harder, all I could find required tools.

Thanks

 

[MGYSGT]

I bought an adjustable but plate for an AR. About $65. ground the base plate on it to fit my Savage Prone rifle and now I have a adjustable buttpad that also cants and moves up and down. If you have a belt sander or disc sander, it is a reasonably easy job.