Quality Gunsmith for Complete Inletting Job

[D-4297]

Looking for a quality Gunsmith to perform a full inletting on a GRS Hybrid stock , to include Pillars , and Anshutz Rail slot . The issue is the action is a Kelby Panda . Left Bolt / Left Port , but Right-handed shooter stock . And the Manufacturer does not do any Right to Left / Left inletting . The Stock is a White Birch Laminate . Appreciate any serious responses to this .

GRS confirmed a 11 - 12 week lead time for the Flat - Top Blank , and I'm trying to line up my ducks ahead of time .

 

[spike-55]

KW Precision does some damn fine rifles on here. Usually on here as @Cigarcop
stan

 

[spike-55]

Alex Wheeler is also first rate
stan

 

[farmerjohn]

As is Mike Davis, he just did two for me,both of them were kelby, John

 

[farmerjohn]

And I might add, we are blessed on this site with some great craftsman, at least two of the above are site sponsors and are first class fokes from first hand knowledge, John

 

[butchlambert]

I'm sure all of the above are top notch. KW Precision "cigar cop" has done 3 for me. They look so good I hate to put metal in them.

 

[Dusty Stevens]

Kelbly can inlet for a panda and they sell grs stocks so they are familiar. Chad up at long rifles in sturgis also does a very good job

 

[NZ_Fclass]

Looking for a quality Gunsmith to perform a full inletting on a GRS Hybrid stock , to include Pillars , and Anshutz Rail slot . The issue is the action is a Kelby Panda . Left Bolt / Left Port , but Right-handed shooter stock . And the Manufacturer does not do any Right to Left / Left inletting . The Stock is a White Birch Laminate . Appreciate any serious responses to this .

GRS confirmed a 11 - 12 week lead time for the Flat - Top Blank , and I'm trying to line up my ducks ahead of time .

Lovely stocks. I have a couple. Great fun getting a centre line though, as there are no straight lines on the stock. Lots of measuring sorts it out.

 

[tobnpr]

Check with Chad Dixon at LRI.
If he's got the code for it, you're probably all set.
For a full inlet job CNC is the way to go.

 

[LVLAaron]

PM'd you

 

[D-4297]

This is exactly why Accurateshooter is the best site on the web . I spent two days full days wearing out my dialing finger , and going to many sites looking for a "Smith", and as usual , my wife said , "Why don't you ask those people on your gun web-site"? .....Well , DUH ! Want to thank everyone for all the responses so quickly . I can move forward with my project knowing there are quality guys out there who will do this job for me .

By way of information to others in this situation : I called Kelby's and spoke with Jim . He told me they no longer handle the GRS Stocks , as I had inquired about the availability of the GRS XEater stock , also . That stock has be dis-continued by GRS , for some reason . And said they were not doing any Laminate stocks , either . Didn't go into why they went in that direction , but was polite and cordial , in the Kelby manner . Almost felt like I should be apologizing to him for asking .