Pulling small bullets

[Orofinobob]

For the first time I erred in loading some 32 gr in a 20 Vartarg case.Tried to save them with an inertia puller that I've used for years with no luck.I guess its because theres not enough weight to create inertia ? What do you fellows use on the lightweights?

 

[PAshooter20BR]

I have a 20 BR and also need to pull some bullets on occasion. I use a dillon kinetic puller and have no problems. You do how ever have to hit the puller very hard off off a cement surface. Mine does not work when using it on carpet. I hit it so hard sometimes I think that it will break...but it does not, a few blunt hits and the bullet usually falls out.

 

[Preacher]

To save some money instead of buying a collet puller, trash these few bullets you have loaded by taking the die out of the press you use and run the loaded round up into the opening and grab those little buggers with a pair of side cutters and pull up or down on the handle and pop the bullet out... A washer under the cutters will prevent any damage to the press......... If your careful you can even use them for plinking or foulers
when your finished...........

 

[JohnJ]

here`s a lil something to try....seat your bulletts a little bit deeper to break the neck tension...worked with my 22/53s


hopes it helps

JohnJ