PTG savage truing tools

[Concha]

Besides the gen II option what is the short list of required tooling to do small shank actions.

 

[Rustystud]

Lathe
Vertical mill
Four jaw Chuck
Action truing jig
.4985" x12" mandrel
Pairs of .500" ID x .699" thru .705" pilot bushings in .0005" increments
A good stiff carbide ID boring bar
A good stiff carbide ID threading bit.
A carbide piloted .703" Reamer
.500" carbide end mill
Measuring tools for OD, ID, to .0005"
A feeler Gauge set.
Some high quality heavy cutting oil
The knowledge and skills to use the afore mentioned equipment and tooling.
You can buy a piloted tool set from Manson or PT&G to get all the tooling you will need your looking at around $1000.00.
I would recommend you read up on Bolt Timing and Primary extraction.
Nat Lambeth
.