• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Phase II Quick Change Tool Holder

mrbill2

Silver $$ Contributor
I would like to buy a Phase II quick change tool post holder for my Atlas 12x36 lathe. Series 100 9-12 swing and series 200 10-15 swing. Which series should I buy, 100 or 200?
Thanks
 
You want whichever of the two will allow you to adjust the height of the QC toolholders to match the height of the carriage/compound above the ways of your Atlas lathe. The best way to figure this out is to pay a visit to this webpage: http://littlemachineshop.com/info/qctp.php
 
You must log in or register to reply here.

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
165,860
Messages
2,205,005
Members
79,175
Latest member
rlk99

Share This Page

Back
Top