Not sure what to call it but I want one

[ftrrookie]

Does anyone make/sell a adapter that fits on the bottom of a sloped stock converting it to a flat bottom so it rides the bag straight back? I would try to whittle one but when I try to make anything out of wood I end up with a pile of sawdust and toothpicks

 

[Terry]

http://www.sinclairintl.com/shooting-accessories/benchrest-equipment/forend-benchrest-adaptor-prod35661.aspx

 

[nhm16]

Does anyone make/sell a adapter that fits on the bottom of a sloped stock converting it to a flat bottom so it rides the bag straight back? I would try to whittle one but when I try to make anything out of wood I end up with a pile of sawdust and toothpicks

It's called a bag rider.

I've had/have, the Whidden Track Plate, the Sinclair fore end adapter, the EGW bag rider for AR-15 foreends (they also make one for Picatinny rails), and a custom Delrin one made by my smith that attaches to a picatinny rail (all my non-F-Class bolt action rifles have Picatinny rails on the bottom instead of a sling stud, to mount an Atlas bipod).

All of them work pretty good, except for the Sinclair, which I found fussy to mount and prone to rotating. Nowadays I use the Whidden plate and the custom made one exclusively (since it also attaches to the bottom of AR-15s with quad rails, etc.).

 

[navyrad8r]

http://www.gotxring.com/fclass/

rookie,
kind of a long shot, but I bet if you called Gary Elesio or PMd here in the forum (gme) he would hook you up with the bag rider part he uses in the tube guns. I hope this helps or was close to what you were looking for. ???
cheers,
Doc

 

[ftrrookie]

Thanks guys but what I'm looking for would fit on the back, behind the trigger to remove the angle, riding on the rear bag.

 

[hogpatrol]

I made one out of a piece of delrin. Measured the angle, cut a radius to halfway align it to fit the stock, cut a male 45 degree on the bottom to fit the bag and drilled & counterbored a hole to attach using the rear sling swivel screw.

 

[Nomad47]

This one was made from a piece of 3/4" PVC pipe. It would be hard to get any cheaper. Attaches in the sling stud hole.

 

[hogpatrol]

More pics added & edited the mfg. method.