Need new high quality case trimmer

[DennisH]

There is a certain degree of 'feel' with the Giruard to get each piece trimmed to the exact specs you want. The Giraud indexes off the case shoulder.

The above is correct! But it's not difficult at all. In 2 minutes I had all my brass cutting withing .001 consistantly.

All I need now is a Giraud Annealer!!!!! YOU GOT ONE?

DENNIS

 

[Leaddog]

No, I have a Benchsource. For annealing, I don't think it gets better than the Benchsource. Check them out.

 

[FroggyOne2]

I trim with the Wilson, the I use the K&M case holder that you chuck in a drill that comes from the neck turning kit, and spin the case in a drill, toiching the case mouth with a chamfer tool on the outside, then use the Lyman 11 degree inside chamfer, then while it is still spinning, I hold some steel wool and buff the case mouth in the steel wool for a few revelutions and remove from the case holder. So I trim all the brass first then finish them later doing the other steps, it don't really take all that long to do a couple hundred.