need a little help

[Richard Coody]

i have a bald eagle slingshot with a shadetree top. i would like to replace the back foot with a lower profile one. I see plenty of them on other rest that would suit my purpose but i can't seem to find anyone who sell just the foot.

it is the cast iron with 1/2" feet.

any ideas would be appreciated.

 

[Dusty Stevens]

Let me tell you what i used to do back in the day. Cut the foot threads off where it sticks down under the bottom like normal but the threads only go halfway into the leg. Then get a short set screw (im guessing 1/2x20) and thread down in the top. Trim them up til the setscrew sits flush with the top and itll look good

 

[butchlambert]

Richard, you do not need the rear screw. Replace it with a 3/8X16 long setscrew. You don't need the factory screw. You have a lot of vertical with your rack and pinion rough adjustment and your mariner wheel.
I do have an email address and phone number on my website.

 

[nmkid]

I've been using my Slingshot without the rear screw, without any problems. However, I don't shoot any high recoil rifles.

 

[butchlambert]

If your rifle is set up properly recoil is not an issue.