Neck size and shoulder bump 300PRC with 6.5PRC Forster die

[300SALRH]

Any potential challenges in neck sizing and bumping the shoulders back on an 300 PRC with a 6.5 PRC Forster neck sizing bump die?

 

[moondog]

Yes, they aren't close to the same case

 

[DaveTooley]

Shoulder diameter is essentially the same. The shoulder angle is the same. Check the ID of the neck area on the 6.5 die. might be too small. The problem will be the body will probably expand causing loading and extraction issues if you don't already have those problems. I never touch a shoulder with anything less than a FL die. Just never works out using something else.

 

[300SALRH]

Thanks Dave.