Neck Bushing Problem

[Nicklas]

Dusty
I recall an interview where Speedy Gonzalez was discussing the type (Speedy) die and he took .015 off the base then drilled out for the bushing.
I can't remember who did that interview, any idea?

Erik Cortina at Youtube.

 

[RegionRat]

The die part # is 71223. I am picking up a old rock chucker this weekend. Before I started this post I searched the forum for similar problems the most common " fix " was to remove material from shell holder, which is impractical on a CO-AX press. I know the die is " neck only " and is technically not designed to bump, but I have never had this problem before with a redding die. I should have bought the forster die ect. The rifle is a HS Precision by the way. I have been from the school of neck size only, work the brass as little as possible ( for bolt rifles ) I almost never full length size, for fire formed brass in same rifle. This is a 1st for me having this much bolt resistance closing on a fire formed case.

@Jtate The 71223 is a Neck Die and the 77223 is a Bushing Full die.

If you want to size the body, you can now just get a body die.