Monday nights in the workshop

[Seagull]

What else do you do when it's 9 degrees Celsius go in the shed and start drilling picatinny rails . Only got to finish 200 of them .

 

[PatMiles]

What else do you do when it's 9 degrees Celsius go in the shed and start drilling picatinny rails . Only got to finish 200 of them .

Start looking for a warmer place to live?

 

[Seagull]

Start looking for a warmer place to live?

Be about the coldest it gets here . Well until we go contract shooting for a bit then it gets cold probably down to zero at times . But no snow where we going to so that's 1 good thing.

 

[joshb]

I’d take it over the heat we’re getting! 97 F and 90% humidity here on the US east coast. I’ll be shooting pistol with my younger son in law, tomorrow morning. He called me to ask if I’ll be OK in the heat. I must look older than I feel.

 

[ebb]

I am looking for that here, bring it on!! If we could get a big cold snap for about a week, freezing or just a little below it would kill off all the iguanas. And what a good thing that would be. https://www.ebay.com/itm/1543868441...0sCtDQyxUcXzCeBT3LDq8HC1k=|tkp:Bk9SR-aQ5rbwZQ

 

[Seagull]

What damage do iguanas do to crops over there ? Or do they just reproduce like rabbits?

 

[hoz53]

What else do you do when it's 9 degrees Celsius go in the shed and start drilling picatinny rails . Only got to finish 200 of them .

looks like youre doing it the old fashioned way. in a mill drill no less.. thats wat ive got towork with. did you anodize them and cut the slots to. mabie i should snowbird down under when it gets hot here. of coarse id wanna stay when summer gets there to see the sights on the beach

 

[Seagull]

looks like youre doing it the old fashioned way. in a mill drill no less.. thats wat ive got towork with. did you anodize them and cut the slots to. mabie i should snowbird down under when it gets hot here. of coarse id wanna stay when summer gets there to see the sights on the beach

Yes round column mill drill and it gets a hammering trust me . Yes mate do the whole process . Had a profiling tool made to do the sides of the rail. Then had another tool made for doing th radius for different actions aswell . But luckily a few actions have the same front and rear radius so didn't need to have heaps made . Also have a flat bed cnc router but need to learn how to do all the technical stuff to get it going