I'm developing a new load using Hornady 40 gr V-Max BT bullets for a new to me Cooper in 223 Remington. I've loaded very few short, 40 gr bullets in ANY of my guns in this caliber, so while I have experience reloading in general these tiny 40 gr bullets are driving me nuts!
The Cooper is a slow 1 in 14 twist with a comparatively short throat.
I usually do my initial loads putting the bullet's ogive fairly close to the lands: for instance with this rifle and 55 gr bullets I used about 0.005 jump. However, if I try to be that close to the lands with the 40 gr bullet I'd end up with almost no bullet in the case!
I remember an old rule of thumb: 'Keep about the diameter of your bullet inside the case to provide decent 'pull' on the bullet when it's fired'. Now, if I put .2 in my 223 cases I'll have a huge,to me) bullet jump to the lands.
I have settled on these numbers with the tiny 40 gr Hornady bullet. I welcome any comments you might have!
> Hornady 40 gr BT V-Max,everything below is in inches)
A. I measure 1.89 length to the ogive with the bullet touching the lands for this rifle.
B. Length to the bullet ogive I chose for my seating depth: 1.865
C. Estimated bullet jump to lands,A-B) = 0.025,farther than I use with heavier/longer bullets)
D. Estimated bullet/case contact length in case: 0.12 - 0.15,doesn't include the BT non contact part of bullet in the case)
Since these rounds will be shot in a single shot bolt action rifle I figure I don't need the full 'bullet diameter' in the case. I just have to be careful handling the loaded rounds so the seating depth doesn't change. I know one thing: if these 40 grainers work okay I will not use BT bullets as they require too much bullet in the case! I'll have to find some flat base versions........
I have not shot any rounds in this rifle yet..........maybe this coming week.
The Cooper is a slow 1 in 14 twist with a comparatively short throat.
I usually do my initial loads putting the bullet's ogive fairly close to the lands: for instance with this rifle and 55 gr bullets I used about 0.005 jump. However, if I try to be that close to the lands with the 40 gr bullet I'd end up with almost no bullet in the case!
I remember an old rule of thumb: 'Keep about the diameter of your bullet inside the case to provide decent 'pull' on the bullet when it's fired'. Now, if I put .2 in my 223 cases I'll have a huge,to me) bullet jump to the lands.
I have settled on these numbers with the tiny 40 gr Hornady bullet. I welcome any comments you might have!
> Hornady 40 gr BT V-Max,everything below is in inches)
A. I measure 1.89 length to the ogive with the bullet touching the lands for this rifle.
B. Length to the bullet ogive I chose for my seating depth: 1.865
C. Estimated bullet jump to lands,A-B) = 0.025,farther than I use with heavier/longer bullets)
D. Estimated bullet/case contact length in case: 0.12 - 0.15,doesn't include the BT non contact part of bullet in the case)
Since these rounds will be shot in a single shot bolt action rifle I figure I don't need the full 'bullet diameter' in the case. I just have to be careful handling the loaded rounds so the seating depth doesn't change. I know one thing: if these 40 grainers work okay I will not use BT bullets as they require too much bullet in the case! I'll have to find some flat base versions........
I have not shot any rounds in this rifle yet..........maybe this coming week.