max loads

[wolf]

.i am hoping someone can help me on this subject . i am shooting a 6mmppc my current load is 28.8 grains on n133 this load is very accurate in my gun but is above the the max loads data given in the vitavorhi reloding manuel i have found i do not get good accuracy with loads less than 28.5 grains of n133.
i have read on this site in the articles pages 6mmmppc competition shoooters using 29. and 29.3 grains of n133 this is along way above the the max loads given but they get great accuracy.
i get no signs of over pressure sticky bolt flattened primers ect so am i ok to continue using this load or could i be daminging my rifle without knowing it.thanks.

 

[tightneck]

Only your rifle can tell you if your loads are too hot, but I can tell you that the load in question would be considered mild to most BR shooters. I have shot as much 133 as I can get into the case with no pressure signs,30.6 grs). That was with one Krieger that I had, with another I had a little cratering, but not what I would consider excessive. These are minimum chambers and a BAT actioned rifle. Your rifle and brass will tell you when its too much.

 

[wolf]

thanks for the replys will be stayng with my current load really didnt want to change it as it shot so good.