jpattonr
Gold $$ Contributor
Found this shotgun blank set sitting in my grandfather's rifle blank pile. Rough shaped and I believe Birdseye Maple or Burl. I'm not sure who the manufacturer was, hopefully by the stamps someone could tell, though he did frequent the Bishop and Fajen shops quite often. I'm not a woodworker, but I cannot see any flaws that would make these unusable. Rifle bolt not included, just used for propping up the wood. Measurements below, and please forgive me for not knowing if there are more important measurements to the shotgun world, I'll be happy to answer any questions:
Fore end:
11.25" long.
1.50" channel at the rear, 1.125" at the front.
Total width 2.25" at the rear, 1.50" at the front.
Buttstock:
13.25" long
5.75" tall buttplate, 1.75" at the widest
Front is about 1.5" wide, 2" tall
Asking $250 shipped lower 48
Fore end:
11.25" long.
1.50" channel at the rear, 1.125" at the front.
Total width 2.25" at the rear, 1.50" at the front.
Buttstock:
13.25" long
5.75" tall buttplate, 1.75" at the widest
Front is about 1.5" wide, 2" tall
Asking $250 shipped lower 48
