SELLING Magpul PRS Gen3 bag rider.

[itchyTF]

Made of delrin. Surface parallel with buffer tube channel within .001”. 5/8” wide, 4-1/2” long. I made aluminum “nuts” instead of using M-Lok nuts. Surface area for engagement isn’t very much especially for plastic.

This may not apply for those shooting actual PRS but for those that have this stock and are using a rear bag for another purpose, this should help.

$30 shipped lower 48.

Listed elsewhere.

 

[itchyTF]

^^

 

[itchyTF]

To resurrect…

 

[Gerimee19]

Is there a way to make this work with the picatinny on the bottom of a Gen 2 PRS?

 

[Gerimee19]

Is there a way to make this work with the picatinny on the bottom of a Gen 2 PRS?

Maybe a smaller version of your front bag rider for the RPR that attached to the handguard on the picatinny to work on the Gen 2 PRS?

 

[itchyTF]

I have no hands-on experience with the Gen 2. If it’s the same as the PRS Lite, I can’t see a pic rail from pictures.

Not sure what this means - “Maybe a smaller version of your front bag rider for the RPR……”

I made a pic rail bag rider for a Midwest hand guard and an adapter with stud for a bipod.

 

[Gerimee19]

I can send a picture tonight when I get home. The Gen 2 has a Picatinny rail that is hidden under a cover to attach a mono-pod. The cover slides off exposing the picatinny.

I noticed you had a bag rider that attached to the picatinny rail of a handguard. Is it possible to make that more narrow to work on the rear while attached to the picatinny?