Lyman Super Targetspot crosshair replace

[TrapperBR549]

As the title says, I have a Lyman Super Targetspot I got from my dad that is in nearly perfect condition except for the crosshairs. Somebody replaced them years ago and they are obviously homemade, very thick and not straight. I would love to get it made right.
I am looking for suggestions on who can do this type of work.
Thanks!

 

[Herzo]

You might try Ironsightinc.com in Tulsa, OK

 

[cardman5448]

Precision Optics...New Mexico

 

[dellet]

Both of the companies below will do crosshairs repair. The two above are very good.

Services Prices

Check out http://targetshooteroptics.com! Services and prices offered to the precision accuracy shooter for telescope optical performance improvements

targetshooteroptics.com

Vintage Gun Scopes

Vintage Weaver, Redfield and other Vintage Rifle Scopes, Guns, scope rings and mounts for sale.

www.vintagegunscopes.com

If you’re adventurous and have basic tools, it’s not hard to do. If yo have fly tying skills and set up, you’re pretty well ready.

Depending on power. .001”, or .0007” tungsten wire works very well. Plenty of people selling a few feet online. “Tungsten wire for scope repair” gets you plenty of sources.

You need about 3”, but if you’re like most people, you’ll break a few getting the hang of it and use a foot. Pretty easy to over tighten the screws holding the cross hair and cut it.

Plenty of inline instruction.