Looking for loads with the 6 Creedmoor

[brianc74]

As the title say's. I am looking for some load data and some info on experience with the 6 Creedmoor.
My barrel is a Krieger 22" 1-8 Remington varmint taper
I am wanting to shoot Berger 105 vld hunting
Just finished seasoning. Round count is 65

Brian

 

[Keith Kilby]

Brian,
I'm running a 105 hybrid at 3125 FPS ( chrono ) from a 26" Bartlein 1-8" HV taper. I'm using 41.5 H4350 and a Remington 9 1/2 primer. My initial tests were with F210M primers. Once I shot my loads over the chrono I went to the Remington primers -cut ES and SD in half and groups at 500 M were much smaller. This load is in the range George Gardner at GAP found to work in most of the rifles he's built and tested. Exceptionally accurate and a hoot to shoot. I shot a couple of F-class matches with mine this fall.

Keith

 

[brianc74]

That is some great info.
Keep it coming.
Brian

 

[brianc74]

Thanks for the load info. Tried 41 and 42 grains of h4350, Shot .6 inch at 100 yards. Put the bullets 15 thou into the lands. Tried cci200 and fed210m. The chi did way better than the federal primers for es. Am going to get some rem91/2 tomorrow.

 

[MikeCTX]

I have been shooting with RL19, as H4350 just did not perform all that great for me (it does wonders with my 6.5 Creedmoor just not the 6 Creedmoor). Would start around 41.0 and go up and down in +/- .2 increments. Found my sweet spot around 41.8, and it shoots great. Use Fed 210 GM, but have also used Rem 9 1/2 mag also.

 

[LitLBoy]

Might want to consider 7828SSC and BR-2
LitLBoy