• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Loaded neck diameter of 6BRA with Alpha brass

tillroot1

tillroot1

Misplaced Wyoming Lineman.
Gold $$ Contributor
Folks, I am looking at building a 6BRA, I am hoping to do a non turn chamber. Could I get any numbers that you could share as far as loaded neck diameter on Alpha brass? I located a Reamer that is a .268 n/d with .104 freebore. Any advice is appreciated.
 
Actually my new Alpha when measured with a micrometer is .270 My necks were measuring .0135 thick. Talking to my gun smith we decided a .274 reamer was needed to go no turn This was the OCD brass
 
You must log in or register to reply here.

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
166,224
Messages
2,214,373
Members
79,485
Latest member
bhcapell

Share This Page

Back
Top