Light weight Stock, who makes

[Dubya]

Do any of the stockmakers build a light weight stock,under 3 pounds) that is for prone or F-class shooting that can be fiited with an adjustable cheek piece?
Thanks.

 

[Forum Boss]

The McMillan F-Class stock can come very close to that weight as it has carbon in the forearm, and it can be delivered with an adjustable cheek-piece from factory, though that will add a little weight. The new Kelbly "1M" stock, featured in last week's BLOG, has a minimum weight "about 3 lbs" acc. to Jim Kelbly. The 1M doesn't have an adjustable cheek-piece, but that could be fitted by someone like Alex Sitman, MasterClass Stocks.

Kelbly 1M:

 

[Cheechako]

Dubya

Try over on long range. They have an F-Class Forum and a lot of those guys shoot stocks with adjustable cheek pieces.

http://www.long-range.com/forums/

Ray

 

[Kav]

The McMillan F-Class stock can come very close to that weight as it has carbon in the forearm, and it can be delivered with an adjustable cheek-piece from factory, though that will add a little weight. The new Kelbly "1M" stock, featured in last week's BLOG, has a minimum weight "about 3 lbs" acc. to Jim Kelbly. The 1M doesn't have an adjustable cheek-piece, but that could be fitted by someone like Alex Sitman, MasterClass Stocks.

Kelbly 1M:

Not sure if yuo could add an adjustable cheek piece to this critter. It is stuffed with expandable foam,I believe)similar to a Lee Six stock rather than the micro-sphere material McMillan etc use t/f it may not be cost wise to cut into one for it would have to be filled in areas.

 

[Dubya]

Thank you all for your input. I'll have to do some research and
see what I can come up with.
Thanks dubya.

 

[sixpointfivebandwagon]

Kav,

Mine was totally hollow. I discovered that when I cut through the fabric layer while doing the mortise for the bolt handle. They are pre molded for pandas and my viper handle rests deeper than a panda does. I did shoot the stock full of foam for dampening.