Leopold 45-45.

[blvedere]

What is the trick to align the 0 on the turret after you zero the scope.

 

[JEFFPPC]

Loosen the screw in the center of the current about a half to 3/4 of a turn counter clock wise, rotate to zero then retighten.

 

[powderbrake]

On my Leupold 45x , I found it very difficult to adjust the zero, because it would change as I loosened or tightened the screw. As JEFFPPC said, just a small amount of loosening before adjusting.

 

[JEFFPPC]

You need to hold the turrent in place as you both loosen and tighten the screw. Easiest to do with the correct torx driver rather than the little provided tool

 

[Lesloan]

Loosen the screw in the center of the current about a half to 3/4 of a turn counter clock wise, rotate to zero then retighten.

Don't turn the screw too far, though, or it'll fly apart! (Voice of experience)

 

[JEFFPPC]

Ha ha, yes. Then it's a bugger.

 

[Pietro panama]

Struggling---know have done before, but after loosening and retightening, no longer clicks???

 

[Pietro panama]

Disregard.Figured it out.