butchlambert
Site $$ Sponsor
Lathe turning Pins out of a pin set
- Thread starter AWLEAPHART
- Start date
B Nettesheim
Gold $$ Contributor
This sounds like an easy job with a tool and cutter grinder!
I was in the same quandary on how to taper additional gauge pins when I bought Kenny Porters mandrel die. I do have a lath but hesitated so I chucked the pin up in my cordless drill and roughed in the taper. With the pin still in the drill I polished the pin on a 3M Scotchbrite wheel and then over to a muslin wheel charged with green polishing compound. The taper was nicely polished and the opposite end could still be used as a gauge pin for measuring holes.
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.