Is this any good for a 10/22?

[Paddyd]

Is this acceptable from a semi auto?

 

[ELR LVR]

Is this acceptable from a semi auto?

More than acceptable
Semi or Bolt

 

[dhagerty40]

i wished my CZ455 shot that well!

 

[Straightshooter1]

Is this acceptable from a semi auto?

Pretty good! Now . . . is that repeatable?

 

[Idaho-Lefty]

Is this acceptable from a semi auto?

What Brand of, Barrel ??

 

[Idaho-Lefty]

My Green Mountain, SS, 20 inch Barrel on my 10-22 will shoot, in the 3's and 4's,.. repeatedly
( 5 shots @ 50 yds ) with, SK Standard Plus and Wolf, Match extra,. BUT the 2.25 Pound Trigger, holds the Rifle "Back",.. IMO ( It's set up as,.. a Hunting Rifle ).

 

[Paddyd]

What Brand of, Barrel ??

It's a Volquartzen I bought almost 30 yrs ago. And it only really like SK ammo for some reason, but it really like it! Eley shoots about the same as standard velocity CCI and RWS about same as cheap bulk.

 

[Paddyd]

Pretty good! Now . . . is that repeatable?

Well of course not every time, but it pretty much always shoots under 1/2" with its preferred ammo. I'd say regularly in the mid .3's.

 

[LAH]

Acceptable to me.

 

[tmwinds]

I would give my left nut if I had a 10-22 that shot like that!

 

[Paddyd]

My Green Mountain, SS, 20 inch Barrel on my 10-22 will shoot, in the 3's and 4's,.. repeatedly
( 5 shots @ 50 yds ) with, SK Standard Plus and Wolf, Match extra,. BUT the 2.25 Pound Trigger, holds the Rifle "Back",.. IMO ( It's set up as,.. a Hunting Rifle ).

I'd like to have a single stage Kidd, but they're pricy.
Before I installed the Volquartzen hammer and sear, I did a crazy youtube trigger mod that actually made the Ruger setup good. It involved putting a dab of JB weld on "I think" the sear that limited the depth the sear engaged with the hammer notch. You put the epoxy on and after curing you cocked it and tapped the trigger assembly with a mallet. Usually it would go off cause the epoxy didn't allow enough engagement. So you sanded down the bump til it "just" engaged enough that it wouldn't trip if dropped or jarred. Got rid of virtually all creep and once you took up the slack it broke like glass. Felt pretty light too even though no springs were changed. If you look for that mod on YouTube you'll be surprised how much better it will feel. If you don't like it you just chip off the epoxy and you're back to bone stock.

 

[Paddyd]

My Green Mountain, SS, 20 inch Barrel on my 10-22 will shoot, in the 3's and 4's,.. repeatedly
( 5 shots @ 50 yds ) with, SK Standard Plus and Wolf, Match extra,. BUT the 2.25 Pound Trigger, holds the Rifle "Back",.. IMO ( It's set up as,.. a Hunting Rifle ).

Hillbilly trigger job using JB Weld on the hammer.
Makes a huge difference over factory. Zero creep

 

[Idaho-Lefty]

@ Paddyd,..
Interesting idea and doesn't Hurt, the Parts if, wanting to ever, change back to, original !
Thanks, for the idea !
My trigger is OK for, Sage Rats and Rabbit, Hunting BUT,. I may do "This" Trigger Mod to get it down, a Bit More.
I would Like, a 1.25 Pound Trigger Pull,... instead of,.. a 2.25 lb Pull !