is there a 223 rifle bullet feeder for a dillon xl650

[philschoppers]

Hey everyone , I'm looking to see if there is a 223 bullet loader that I can use on my Dillon do650 loader . Figured it would speed up the amount of bullets I can load . I see rcbs and hornady make a pistol bullet feeder .

Thanks for any info

Phil

 

[Duster_360]

Seems there are couple of options, the best one and the one I'mm looking at to add to my 650 is the one by these guys - it's an expensive option and I just want to be sure I want the 650 and not the 1050...can get conversion and do both pistol and rifle bullets. Rate seems to opnly be limited by how fast you can cycle the press.


http://www.mrbulletfeeder.com/


If you google "bullet feeder dillon", there are threads about adapting the RCBS one to the 650.

 

[CatShooter]

Seems there are couple of options, the best one and the one I'mm looking at to add to my 650 is the one by these guys - it's an expensive option and I just want to be sure I want the 650 and not the 1050...can get conversion and do both pistol and rifle bullets. Rate seems to only be limited by how fast you can cycle the press.


http://www.mrbulletfeeder.com/


If you google "bullet feeder dillon", there are threads about adapting the RCBS one to the 650.

That sounds great (in theory), but in reality, the 223 case is tall and thin, and if you run a 1050 very fast with that case and max (full of powder) loads, you will wind up with 20% of the powder all over the bench, and lousy ammunition (don't ask how I know this ).

If you can keep 650 to 700 an hour, (for many hours) you will be doing fine.