Interchanging stocks

[cycbb486]

I am wondering something. I am getting my Rem 700 blueprinted and chambered for 6BR. I plan on using it for varmint hunting and the occasional uniformal BR shooting. My plans at this time are to bed the factory wood stock but would like to by a true benchrest stock to change when going to the range. The factory wood be used for field use only. I am wondering if this would be a problem as far affecting load development be it that both bedding jobs turn out to be 100%. Would it not be similar to switch barrel except it is switch stock?


Calvin

 

[jb1000br]

As long as the barrel is flaoted and bolts torqued to the same setting, it should be no problem -- I have considered this myself

JB :thumb:

 

[loader]

will work fine been doin ut for a long time, would suggest piller beding both stocks, then set the same tq. on each stock. good luck with it, loader