How do my stock repairs look?

[DHall_37]

This was my first time using dowel pins fixing up a stock. They aren’t perfect and on one of the 2 I didn’t get the end of the crack so like 3 mm of crack is on the right side of the pin.

I don’t plan on shooting any powerful loads through this old Mauser, mostly going to try and get good groups out at 50 yards. So I don’t think it will split any more. Also I filled the cracks with epoxy and the previous owner put some metal pins in it too.

Any further advice is welcome, this was my first time so I don’t reckon I screwed it up too bad.

 

[skywag]

Looks good and strong!

 

[Rat Rifle]

Think You did all You can D. Shooting it should tell if further attention is needed.

 

[DHall_37]

Think You did all You can D. Shooting it should tell if further attention is needed.

Thanks, shot about 50 surplus (very Hot!) rounds and no further cracking. I think it’s good to go even though I didn’t quite get one pin on the edge of a crack.