• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Have you seen this before

I am building a 22XC. I received my Peterson 6XC brass a few weeks ago. Adjusted the die and started necking down the cases. I noticed it was taking a little extra force to neck them down. Did about six and stopped. The holes looked just like yours but worst. Compared them to the un-sized cases. Easy to see the difference. I never thought to look at the de-capping pin before I started. My bad! It had a large de-capping pin in it. The pin is .072 and the SRP brass hole is approximately .065". Pretty close.
 
You must log in or register to reply here.

Similar threads

Has Anyone Seen This Before
Replies
19
Views
795
Mark W
Never seen this before
2
Replies
21
Views
1,949
divingin
Crazy never seen anything like this before
2 3
Replies
52
Views
2,421
searcher

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
166,303
Messages
2,216,203
Members
79,551
Latest member
PROJO GM

Share This Page

Back
Top