Harrells Powder Measure to Dillon 550

[walker]

I am not happy with the powder measure on my Dillon 550. Is there any way to mate Harrells with Dillon?
Thanks

 

[memilanuk]

There is a threaded powder measure adapter (might be under AT500 parts/accessories) that will accept ones like the RCBS Uniflow or Redding BR-30... you can also get case-activated powder drops (CAPD) for the RCBS uniflow and Hornady LnL measures that will thread right into a 550. I use the RCBS version on my 550 for throwing Varget and other short-cut extruded powders. Actually seems to work better than it does when operated 'by hand', as the spring actuator is pretty darned consistent.

The Harrell's measure isn't threaded, so unless you have some special adapter custom made, you may be out of luck. Kind of over-kill for this application anyway - the others will work just fine.

 

[walker]

Thanks for the advise, will consider it.

 

[HPMike800]

I have a Harrels mounted to my 550, you can make an adapter out of a dillion powder measure bottom piece and a chunck of tube. I would go the route above unless you allready own a culver type measure.

Lynn Harrel has some good tubes for the job.