• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Hard Bolt Lift

medicineman,

The firing pin protrusion is currently set up at approximately .050. I think I'll just leave it right where it is, as it has fired fine, hasn't pierced any primers or anything, and hasn't been changed from stock.

SooStan,

I have measured resized cases on the same machine that I measured the chamber on,,and Shilen has confirmed that the reamer is cutting an undersized chamber) so I am confident that the cases are fine. There are no factory loads for this chambering that I know of, so I can't try a factory load.

Thanks,
inspectormac
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,841
Messages
2,204,680
Members
79,160
Latest member
Zardek
Back
Top