Got a question for Winchester 70 guys

[aer21]

I have a friend with a Winchester model 70 .338 ultra mag that started life as a .300 ultra mag. Someone had Christensen arms put a carbon barrel on it. Anyway the question is, does anyone know where I can find a rail for it? The setup he was using required him to move his head and neck forward after shouldering the rifle approximately 2 inches to see a clear picture through the scope because the scope cannot be slid back anymore. My suggestion was to put a rail on it so he could set the eye relief where he needed it but after getting the gun and measuring the hole spacing, I can't find one. Any help?

 

[Milo 2.0]

Ken Farrell industries.
https://www.kenfarrell.com/

 

[aer21]

Ken Farrell industries.
https://www.kenfarrell.com/

I don't know if it's just me but I still can't find the one that I need. The hole spacing is rear base rear hole to next one forward, .325. Middle holes are 4.330. Rear base rear hole to front base front hole is 5.515. All these measurements are as close as I can get with calipers, so not exact.

 

[Milo 2.0]

I don't know if it's just me but I still can't find the one that I need. The hole spacing is rear base rear hole to next one forward, .325. Middle holes are 4.330. Rear base rear hole to front base front hole is 5.515. All these measurements are as close as I can get with calipers, so not exact.

Call him in the morning.

 

[Milo 2.0]

I think what you're looking for is their LA magnum, slightly longer than a standard LA.
I think I had the same issue with a 7stw that came from Win's custom shop, KF had the one I needed.

 

[Milo 2.0]

https://www.kenfarrell.com/index.php?route=product/product&path=20_26&product_id=179

 

[aer21]

Thanks very much! I will call in the am.

 

[sean68]

Thanks very much! I will call in the am.

EGW should have this. Check their web site.

 

[aer21]

Egw thinks they have it, I called them with my measurements and they are going to send me one to try. Thanks for the help!