gas gun feeding issues on 6mmAr turbo

[wildchild]

I finally got this thing to eject the 6mmAr turbo empties and now it won't feed em to load. The rounds are sticking about 1/3 out of the chamber, almost as the tip of the bullet is sticking or wedging in the neck/shoulder junction of the chamber. If pull the charger back just a little it goes in. I tried polishing the feed ramps but i don't think thats the issue. Any ideas?

 

[Erud]

Are you 100% sure you are sizing the cases enough?

 

[wildchild]

Are you 100% sure you are sizing the cases enough?

Did you read my whole post? 😁

 

[Erud]

Yeah, I read it. Clearly you already have this figured out, so I'll politely refrain from interrupting you again.

 

[simplerider]

Mr. Whitley recommends putting a small bevel on the inside edge of the ejector to help with feeding. Im guessing your brass is hanging up on the ejector and wedging it in your chamber. I believe he put up a small write up about this issue. a quick search should bring it up, "AR Ejector Mod For Improved Reliability with Larger Cartridges" in bulletin.