Free float tool heads Dillon 550

[JoeInTucson]

So I am running my 3 Ruger Precision calibers on my 550 and getting pretty good results. But of course I was watching YouTube and found something else. There are freefloat toolheads with special die rings. Do any of you use these and have you noticed a on paper improvement?

 

[Hoser]

I have the Whidden toolheads and I can measure the difference with a comparator. Inside a few hundred yards, no difference on target. Past that the difference starts to show up.

 

[DocBII]

Good day,

I have a couple of the Whiddens and 20+ of the Dillon toolheads. Best improvement in consistency came from installing the UniqueTek parts to lock the toolhead to press. I ended up installing them on all the toolheads. I'd recommend getting a reamer instead of using the drill bit included with the kit.

HTH,
DocBII

 

[Mauser06]

I run Armanov heads and rings. I didnt compare targets....I shoot steel and when I shoot, I need ammo.....I simply dlnt have the time to load precision ammo without the setup I run. On paper and steel, I know it hangs with guys spending a lot more time making ammo.