Forster Co-Ax Handle

[454bore]

Question for those who own a Forster Co-Ax.

I recently received a Co-Ax and upon opening the box, found that the hole in the yoke where the handle is installed is off center and that the casting is pretty poor quality as the wall thickness is not consistent (the one side is half the thickness of the other). For the price of the press I am considerably dismayed at this quality issue.

Is yours the same way or did I get a lemon?

Thanks.......

 

[7stubby]

Just went and looked at mine and its the same thickness all the way around. I don't see that it would hurt anything, but if you feel that it will effect the way of your reloading then call Forster and let them know about it. Its a manufacture defect, not a distributor defect. The people at Forster are good people to talk with. Just my 3 cents. Jake

 

[Nomo4me]

If I had to pack it up and ship it back to a mail order house I'd probably use it as is.
If it's really going to get under your skin then send her on back.

 

[Kenny474]

I would call Forster and maybe even see if you could e-mail them the pics. They will most likely have no issue with making it right.