Finally received my rifle after 18 months

[TheSilverFox]

Well heres my toy, All i still need is a badger base.
308 special Match " Spencer"
A-5 Stock
Jewell Trigger
Stolle Grizzly II Action
S&B 5-25 optics

Rifle built by Clay Spencer Fit and finish is outstanding

 

[BHarvey]

VERY nice rifle.

 

[BillK]

The Chuck Norris stuff almost cured me from having to go to work tonight-because I almost laughed myself to death!!!!!

 

[tripcrow]

Silverfox, what's that little noob ahead of your trigger? I have a Griz2 w/Jewell & ain't got one of them.

 

[tripcrow]

Ahh, you got the repeater. It's for the floorplate?
Very nice.

 

[Baron]

tripcrow,
That is the Safety Lever on a Bottom Safety Jewell Trigger.

 

[tripcrow]

Thanks Baron. Guess I oughta get off the bench and get around a little more.

 

[Dave223]

Wow that's a good looking rifle and if that wasn't enough, you've got a choice scope there too. Beautiful.

 

[Cheaha]

Very classy!!

Now where's the load development results ???

 

[TheSilverFox]

Murphy's law.

Got the rifle on friday

loaded 6 different loads on saturday

Went to shoot on sunday at the range and it was closed for a 3 gun match.

So it will have to wait t'ill tuesday

Man thats sucked.

 

[TheSilverFox]

OK, back from the range.

Here's my three best groups out of ten groups shot at 300 yards. Bripod with sandbag.

New brass mind you.

 

[kells81]

nice rifle, but it looks like he wrote his name on it with an etch a sketch!! is that how he marks all his rifles? or did he make a boo boo?

 

[TheSilverFox]

i guess the etching is kinda gay but it couldn't care less.

 

[tightneck]

nice rifle, but it looks like he wrote his name on it with an etch a sketch!! is that how he marks all his rifles? or did he make a boo boo?

That's interesting. I never payed that much attention to the engraving on his rifles, but I do seem to recall that they looked like that. It's funny too, that man has so much money tied up in his shop that it would make ANY gunsmith jealous. I've never seen a shop that even came close to having the equipment and tooling that Clay's has. He does all his chambering on a $80,000 CNC lathe...

 

[kgunz11]

John Whidden uses a CNC lathe too. Heck if you really want to get down to it, John Whidden turns his Lapua bass on his CNC lathe. What's Chuck got to say about THAT! LoL