• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Expanding case necks

I myself use a spray type, one shot, Dillon, etc.. I use a home brew spaying into the necks, way to slow for Imperial, as each case needs it, gets scraped off mandrel each stroke.
 
Last edited:
I do not use any lube for this step. It never occurred to me that it is needed for this operation. I am surprised that others use lube for this. I am not aware that this has caused me any problems. But I may be missing something. I am sure that those who use lub will jump in and explain why they think it is necessary.
 
chkunz,
Even though you are using a carbide mandrel, you run the risk of galling the case neck. Yes it is substantially less with carbide, but anytime you are dealing with a press fit situation galling is a possibility. If this happens, you now have an abraded surface that you are seating a bullet on. Probably not real good for accuracy and consistency.;)
Others may have other thoughts, but this is why I lube the brass before every process.

Lloyd
 
I have in fact seen galling first hand and once it gets on the mandrel, the brass that comes after will be affected so you don't get consistent seating pressure. Imperial is the way to go.
 
I agree with Donovan.
I run an expander mandrel through each neck just prior to seating a bullet in that neck. The dry carbon layer in my necks provides perfect seating lube and no other is better or needed.

Any 'galling' with this(it's not galling) is not caused by the hardened expander, but by some contaminant introduced, that is being impinged into the soft brass surface. Maybe in vibratory media, I don't know.
 
When using a carbide mandrel to round out necks of new brass what type of lube if any do you use?
When I am prepping NEW VIRGIN brass for neck turning, I use a carbide expander mandrel and a light coating of Imperial Sizing Wax on about every 5th case done. AFTER the brass has been prepped and fired, I will use the same expander mandrel with NO LUBE to run the sized cases up over the mandrel and then brush out the case necks with a "carboned-up" case neck brush to put a light smooth film of carbon in the neck, prior to loading. This makes for consistent and very smooth seating. As a matter of fact, with VIRGIN brass, prepped the way I prep them, and applying a light coating of Imperial DRY Neck Lube prior to charging and seating, I get just as good accuracy as once fired brass! But a mandrel is ALWAYS used whether virgin brass or fired brass. There is nothing "straighter" for case necks than a mandrel!
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,810
Messages
2,223,515
Members
79,917
Latest member
Joe The Licensed Plumber
Back
Top