I have had several bolts in the shop lately with dual ejectors. Both with M16 extractors. Guessing this an attempt to lower the ejection angle of a fired case. Any experience or thoughts about this? Just curious if it works.
Paul
Paul
Yes it is. It falls under Rule #1
Don't do anything to make the phone ring.
Do you own any Model 700's that have an M16 extractor and a big windage knob?A solution to a non existing problem. I had a large frame gas gun with dual ejectors never
gave me any issues but neither has anything I owned with a single ejector.
Why?In a bolt gun?…I couldn’t tell ya a thing…
In a hot rod AR-10…an absolute must!!
What Old Navy said. Tommy McI have had several bolts in the shop lately with dual ejectors. Both with M16 extractors. Guessing this an attempt to lower the ejection angle of a fired case. Any experience or thoughts about this? Just curious if it works.
Paul
Less damage to the brassWhy?
I use dual ejector bolts with small firing pin on AR 10 in 6 5 Creedmoor and my favorite the 308 win. So how do you think I run 200 gr SKM 710 BC at 2621 ave fps 12.4 S/D in an 18" 5 r Proof 308 Win barrel. An adjustable gas block is a must...also put a rug cushion on your shell deflector and your cases come out hot and perfect. Heavy loads in tbe 6.5 Creedmoor AR 10 with a 24 " barrel were up to 2940 fps with 140 grain...but I prefer the 150 SMK at 2850...I run the same or close to it loads in the bolt guns as the ARs...but I don't have a clue as to why on a bolt gun that you'd need two ejectors...I put a low power spring on some of mine, so the brass doesn't go flying far, far away. AND...it doesn't side load my 6 dasher cartridge with excess pressure while loaded in the chamber...good theory...huh? ...but who knows for sure. Remember ...Some are outside the box...way outside. Plus why would you what or think like everyone else, chart your own coarse... and experiment with what others have discovered,..is it for you? Dual ejectors guy? ...sometimes...Why?