Been reloading on co-ax with some success for 4 years, new Dillon owner....
Setting my powder die to adequately bell cases for 45 ACP....screwed die down until I got .007” flaring, bullet sits nicely in case (manual says flare .010”)...at this setting, charge bar arm touches powder body when operating handle is barely below horizontal....manual says it should just touch at bottom of stroke...turning die up to decrease over travel of charge bar arm will only decrease flaring of the mouth...my flared cases measure .476...can’t figure out how to get proper travel of charge bar arm and adequate mouth flaring at same time...thanks
Setting my powder die to adequately bell cases for 45 ACP....screwed die down until I got .007” flaring, bullet sits nicely in case (manual says flare .010”)...at this setting, charge bar arm touches powder body when operating handle is barely below horizontal....manual says it should just touch at bottom of stroke...turning die up to decrease over travel of charge bar arm will only decrease flaring of the mouth...my flared cases measure .476...can’t figure out how to get proper travel of charge bar arm and adequate mouth flaring at same time...thanks