Die selection for BRA

[Justinmac13]

I am getting my BRA brass all FF and didn’t know if I should send in for a harrells or go with a Redding. My setup is a crescent custom on a origin action, I am not all in on PRS but like doing load development and shooting bug holes the most. I do plan to compete but have not yet. My question is do you think the harrells die will be too close tolerances for PRS style shooting?

 

[Falfan2017]

I like the Harrels. Should still be enough clearance for them.

 

[BoydAllen]

You can call Harrell's and discuss how much sizing you want. If you get the die and want more, I believe that they will exchange it.

 

[JFrank]

I’m working with both Wilson & Harrell’s Precision on my 6 BR-A FL bushing type dies.
Sending those FF cases is the key’ I’m very pleased with both companies.

 

[dgeesaman]

I am getting my BRA brass all FF and didn’t know if I should send in for a harrells or go with a Redding. My setup is a crescent custom on a origin action, I am not all in on PRS but like doing load development and shooting bug holes the most. I do plan to compete but have not yet. My question is do you think the harrells die will be too close tolerances for PRS style shooting?

Harrells for sure. Tell them that if the brass is between sizes to lean on the side of extra sizing.

David

 

[farmerjohn]

Harrells for sure. Tell them that if the brass is between sizes to lean on the side of extra sizing.

David

+1, John

 

[Justinmac13]

Thanks guys, I’ll go the harrells route, I may have to have my Wilson seater reamed out just a touch as they get stuck in there while seating the bullet, I’m just trying to get my 3 firings done so I can send them in. I have them loaded and ready for their second firing now.