DIE HELP? Identify

[RustyPin]

I received a DIE with another set of dies. It's handwritten and it runs together HAG300-270Short-Form, Shoulder measures .451" Near 2.014" High Shoulder & Base measures just inside the Die opening .500". We are reading it as: "300-270 Short-Form HAG" What is this thing?

 

[#40Fan]

What were the other set of dies it came with? That might help to identify.

 

[KMart]

A forming die for some wildcat. The HAG could be the mans initials or short for his last name

 

[RustyPin]

I'm thinking it's some form of Short H&H Magnum in 30 Caliber, oh I did not mention the Shoulder is close to 30 Degrees or more. I don't know how to measure that exactly. I'm guessing it's very very old.

 

[riflewoman]

Run a 300 win mag case into it and then you’ll know. There are so many short 270-300 mags out there. Get a copy of P.O. Acleys handbook. Almost any magnum case on a 270 bore is overbore...

 

[RustyPin]

Run a 300 win mag case into it and then you’ll know. There are so many short 270-300 mags out there. Get a copy of P.O. Acleys handbook. Almost any magnum case on a 270 bore is overbore...

Hey Thanks for the Advice. I do need to get some Ackley Books. I ran a 7-RM Case through it, that's how I got the Shoulder width. It's not anything I will ever use, I just wanted to know what it was. I guess it's just part of my Collection.

 

[MagnumManiac]

Run a 300 win mag case into it and then you’ll know. There are so many short 270-300 mags out there. Get a copy of P.O. Acleys handbook. Almost any magnum case on a 270 bore is overbore...

Honestly, the term overbore barely applies to anything smaller than the 50BMG.
The powders available today are slow enough to negate any overbore condition. I cannot stuff enough RE33 into my 264WM, 270 Weatherby, 300WM, 338 Edge or 338-416 Rigby Improved to get excessive pressure, so overbore is non existant.

To the OP, all I can tell you is it is a ‘forming’ die, has a 30 cal neck and may be a 30 cal 270 Weatherby type case length.