I purchased a economy scope for my brothers new 25-06 savage rifle.. Its the same scope I use on my savage .223 rem. its a cv life 6-24x50 it has very good optics for the money.. so when I bought the ring mounts I opted for the same ring sets I have on my .223 a set of 30mm rings with plastic reducers to 1 inch. I went that route because I liked the idea of a soft material contacting the tube and not torquing the tube out of whack... so the ring set utilizes 4 screws per cap. once all of the thread locker dried I loaded up the gun and headed over to my buddies place to put some rounds down range.so I used fresh targets at 50 yards pulled the bolt out bore sighted the rifle to the target.then I looked thru the scope and the reticule was 2 feet to the left and low 1 foot.. so I adjusted the scope untill the cross hairs rested on the vertical but it would not adjust far enough to the right ..I ran out of adjustment..so i put four rounds in it and sure enough vertical was spot on but right=left was out and I had no more to adjust.. so is this a scope issue or is this a poorly drilled receiver?