• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

dasher fireforming neck tension

Not sure as I use the Lapua factory brass straight out of the blue box. The neck tension I normally use (.0015) is not an issue until the brass is checked for thickness and run through the die.

I jam my factory brass .020 with 29.5 gr. Varget and 107 SMK's. Lost one case in about 160 fireforms.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,835
Messages
2,204,597
Members
79,160
Latest member
Zardek
Back
Top