cz455 ring height

[Regnar]

I have a vortex viper hst 6x24 on the way. i have the dip 25moa base. what rings? i am thinking high but not sure.

Anyone have this set up?

 

[Rob01]

Similar set up with PST 6-24x50 on a 25 MOA mount with .92" height rings. It's close to barrel but not touching.Could probably go 1" height to give room for cap.

 

[Regnar]

Thanks, which rings for you?

 

[TheOtherZilla]

I have a 455, but can't tell ya what scope or rings I have on there.. Unless CZ has changed the bolt handle the scope may interfere with the bolt. I took my bolt handle off and ground it to shape for clearance, then re-blued it.. I am not familiar with an SIP base, but I have used a DIP rail on my 17 Hornet in CZ.. Me? I'd go high rings..

 

[Regnar]

You don't know what scope or rings you have on yoir rifle, you had to grind your bolt to make it work and you reccomend med rings? Thanks but i think Ill wait.

 

[Rob01]

Thanks, which rings for you?

I use Seekins 30mm rings. Mine are .92" height but they make a taller.

 

[Byrne]

I have a 6x24 Viper PST Gen 2 on mine with Burris medium ZEE rings. I wish I had gone with high rings. The bolt clears the scope by about 3/8" with the medium rings.

 

[TheOtherZilla]

You don't know what scope or rings you have on yoir rifle, you had to grind your bolt to make it work and you reccomend med rings? Thanks but i think Ill wait.

Medium rings?? I wrote High... You are welcome.. And since you edited your original post, I now see DIP base, which I have on a 527. I used Talley rings on the 527.. And I still say HIGH for your scope.. Mine is smaller..

 

[Bill K]

I have the leupold VxII-3 in 4x12 and used the 11mm Leupold med rings, cleared just fine and did not need to work the bolt handle over, clears just fine.