CZ & SCOPE PROBLEMS

[BULLET 05]

Just purchased a CZ 527 varmint heavy barrel (listed on this site). I am trying to mount a Burris Full field II 6.5 x 20 x 55. The rings are medium CZ rings but the scope hits the barrel just a little. I look on CZ site and they do not show a high ring. I think Leupold has A set of high rings. Any suggestions.

 

[hogpatrol]

Check out the Talley rings or the CZ weaver adapter:

http://shop.cz-usa.com/ProductDetail/19010_Weaver-Adapter-Rail-527-16mm-Dovetail

http://www.talleymanufacturing.com/Products/Rimfire-Specialty-Rings/CZ-%281%29/1-CZ-Centerfire-527-%28for-Dovetail-Setup%29.aspx

 

[Alex Wheeler]

Use some jb weld and bed your rings, use a spacer to get the scope up higher.

 

[snakepit]

Check out the CZ weaver adapter:

http://shop.cz-usa.com/ProductDetail/19010_Weaver-Adapter-Rail-527-16mm-Dovetail

+1 Also available in a 20 MOA version from CZ.

 

[dkhunt14]

BKL makes high rings and riser blocks. Matt

 

[BULLET 05]

Thanks for all the options guys.

 

[Clod-NC]

Hi Bullet 05,hi all
I'm not sure CZ 527 and CZ 550 use the same base rings,but if so ,then yes Leupold make excellent high sets of base rings for them,I have one on my 550,they're really fine,(they don't leave ring traces on your scope)...,they're all steel,perfectly machined,Leupy stuff,you bet.