CZ 527 Internal Mag

[ab_bentley]

So I am bound and determind to make it work, I need some input.

As you can see there is a recess that runs around the mag well. In my minds eye I can fashion a sheet metal mag, then use one of the followers from the magazine to make the spring and follower. The stock I made has an ADL type mag well allowing me to use a 700 trigger guard. Any input is wanted. ADam

 

[bones284]

Could you cut the bottom of the magazine off, fit it in the stock and use the spring and follower as is.

 

[p17enfeild]

there a few old .425westley richards biult on mauser action as the case are big and fat the normal feed lips did work, so they use two opposing sprung claws, i only have a bad photo in magazine, will try to find it, hope this helps