CZ 527 disassembly question

[bobcat93]

Goodmorning all,
So I took a long break from shooting and stuck inside due to rain storms
Decided its time to clean my guns and see where I left off on my projects..
I pulled the CZ 527 barreled action from the stock and a roll pin fell on the bench hahaha
Now I haven't messed with this rifle in years..6 to be precise if I remember CZ uses a roll pin for a pillar on the rear action screw..is that where it came from?...
Does it need to be installed?...the action sits in the stock better with out it, it also miss a lines the bottom metal and stops the magazine retainer clip from engaging...when it's removed its all good..
Will I crack the little cz 527 stock if I shoot with out that roll pin inserted
Thanks

 

[bobcat93]

 

[L.Sherm]

I've got 6 527's and all have the pin in the rear installed.
Sounds like yours needs bedded.

 

[bobcat93]

I've got 6 527's and all have the pin in the rear installed.
Sounds like yours needs bedded.

Did you bed your roll pin?haha..that sounds funny...ill have to mic. It... I actually don't think its long enough to act as a Pillar
Hmmm..

 

[L.Sherm]

You want the pillar below the bedding.

 

[AlNyhus]

Those CZ 527s really benefit from a well done pillar bedding job. They are challenging to do correctly with the rear pillar being a big part of the project.

Good shootin' -Al