"Custom" Lee Auto-prime shell holders

[ExPiney]

Are there any manufacturers that make the Lee style shell holders but held to tighter tolerances?

I have a set, and there seems to be excessive wiggle room in the recess for the case rim (If I don't put the case in the shell holder just right, it will misalign and tilt sideways).

This is annoying and can cause some of the primers to start seating tilted.

I have found Lee products in general to be quite generous in the wiggle room department, so I'm wondering if it's spec, a bad lot, or ?.

Thanks.

 

[3Ackleys]

I use Sinclair- they are very nice.

SINCLAIR INTERNATIONAL SINCLAIR PRIMING TOOL SHELL HOLDERS

Check out SINCLAIR INTERNATIONAL SINCLAIR PRIMING TOOL SHELL HOLDERS available Online at Brownells Today and many more Shellholders & Shellplates products are available in our Reloading Department.

www.brownells.com

 

[Dusty Stevens]

21st century makes some very nice ones

 

[kenhwind]

I use Sinclair- they are very nice.

SINCLAIR INTERNATIONAL SINCLAIR PRIMING TOOL SHELL HOLDERS

Check out SINCLAIR INTERNATIONAL SINCLAIR PRIMING TOOL SHELL HOLDERS available Online at Brownells Today and many more Shellholders & Shellplates products are available in our Reloading Department.

www.brownells.com

I never realized this.
Although I do not recall any issues with the LEE shellholders it is nice to know of an alternative.

 

[Codeman]

I had the opposite results. I ordered a ppc lee shell holder for use in my CPS primer- to small cases wont go into it. (yes I ordered the right one).