• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

"Custom" Lee Auto-prime shell holders

ExPiney

Gold $$ Contributor
Are there any manufacturers that make the Lee style shell holders but held to tighter tolerances?

I have a set, and there seems to be excessive wiggle room in the recess for the case rim (If I don't put the case in the shell holder just right, it will misalign and tilt sideways).

This is annoying and can cause some of the primers to start seating tilted.

I have found Lee products in general to be quite generous in the wiggle room department, so I'm wondering if it's spec, a bad lot, or ?.

Thanks.
 
I use Sinclair- they are very nice.

I never realized this.
Although I do not recall any issues with the LEE shellholders it is nice to know of an alternative.
 
I had the opposite results. I ordered a ppc lee shell holder for use in my CPS primer- to small cases wont go into it. (yes I ordered the right one).
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,672
Messages
2,200,485
Members
79,039
Latest member
J.FISHER
Back
Top