Consistent Deburr and Chamfer

[Delfuego]

If they did these in 6BR and 284 I’d try them....

Check out the Trim It 2. I had the Giraud Tri-Way, sold it for the Trim It. They have lot of calibers, I had them make a Dasher and SAUM insert for me too.

 

[savagedasher]

If you have a 3 way fixed blade cutter with a pilot nothing can be any difference
I like a motor driven with a total case lingth
But I also load different cases that has the same caliber
Like a 6 mm br a a bra a Brx and a dasher

 

[Boisblancboy]

Check out the Trim It 2. I had the Giraud Tri-Way, sold it for the Trim It. They have lot of calibers, I had them make a Dasher and SAUM insert for me too.

The adjustment on the trim it 2 is nice along with the fact it has interchangeable bushings.

 

[Richard Coody]

for mass production i like the tri-way

but for precision i hand chamfer and debur during every reloading. only takes a little twist or two with a hand tool. i think many overdo it with power chamfer. i know i once did. you don't want to create cookie cutters.

 

[Rope2horns]

Giraud.

 

[Delfuego]

The adjustment on the trim it 2 is nice along with the fact it has interchangeable bushings.

It was much easier to adjust than the Tri-Way. Nicer overall build too. The full blown Giraud is the bees knees, but for hand-drill/drill-press trimmer, I think the Trim It 2 is the way to go. Nice guys too.

 

[Dusty Stevens]

If youre not worried about the deburring while trimming i prefer the pma trimmer. Very easy to use

 

[waltk]

As others have said, the Giraud trimmer is fast and accurate and does inside and outside chamfer at the same time.
Love mine to pieces. With two of us shooting there is no way I could keep up otherwise.

If you want the same results, but don't have the budget, the Giraud Tri-Way is also great
https://www.giraudtool.com/giraud-tri-way-trimmer.html

Frank

This is the answer/solution to your problem.

 

[varget204]

Just the inside, but the out side I’m just giving a swipe to knock off any shards. Not really over doing it. But hopefully a more experienced benchrest Reloader chimes in

The RCBS prep center i have has 5 stations,you can install outside deburring tool easy as screw 1 on.