Commercial Neck Turning using AUTODOD?
- Thread starter tactserv
- Start date
I am looking turning service for 6PPC Alpha brass. Not sure about what the best way to provide brass (new, once fired, once fired & sized with bump die, etc.) is. If once fired only, I would pay for shell holder.
RegionRat
Gold $$ Contributor
Just making noise since you really should discuss this with the service who will run your job...
In GD&T terms, you want the condition with the best cylindricity on the ID and OD of the necks versus the spin axis. Any runout gives you more constraints to achieve a nice cut with 100% clean-up or your desired thickness.
So, whichever condition gives you the least taper and runout, gives the system the best shot at making the batch perfect.
Good Luck, YMMV
In GD&T terms, you want the condition with the best cylindricity on the ID and OD of the necks versus the spin axis. Any runout gives you more constraints to achieve a nice cut with 100% clean-up or your desired thickness.
So, whichever condition gives you the least taper and runout, gives the system the best shot at making the batch perfect.
Good Luck, YMMV
Last edited:
You'd have to contact Greg or DJ (the only two services I know of) and ask them.
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.